The BatteryProtect protects the battery by disconnecting it from non-essential charges before it is completely discharged (which would damage it) or before it does not have enough power left to start the engine.
Very easy programming
BatteryProtect protection can be configured to activate / deactivate at different voltage levels. The 7-segment display will indicate which configuration has been chosen.
A special configuration for lithium-ion batteries
In this mode, the BatteryProtect can be controlled by the BMS of the VE-Bus.
Very low energy consumption
This is an important feature for lithium-ion batteries, especially after stopping at low voltage. Please see our technical sheet for lithium-ion batteries and the VE.Bus BMS manual for more information.
To avoid damaging the loads that are sensitive in the event of an overvoltage, the load is disconnected if the DC voltage exceeds 64 V.
Protection against combustion
No relay, but MOSFET transistors, and therefore there are no sparks.
Delayed alarm output
The alarm output is activated if the battery voltage drops for more than 12 seconds below the predetermined disconnection level. Starting the engine will therefore not activate the alarm. The alarm output is an open collector output protected against short circuits which is connected to the rail (negative), maximum current of 50 mA. The alarm output is generally used to activate a buzzer, an LED indicator or a relay.
Load disconnection and reconnection time
The load will be disconnected 90 seconds after the alarm is activated. If the battery voltage increases again to the connection threshold during this period (when the engine has been started for example), the load will not disconnect. The load will be connected again 30 seconds after the battery voltage has exceeded the preset charge reconnect voltage.
For further information on the nature of the review controls, as well as the possibility of contacting the author of the review please consult our CGU.
No inducements have been provided for these reviews
Reviews are published and kept for a period of five years
Reviews can not be modified: If a customer wishes to modify their review then they can do so by contacting Verified Reviews directly to remove the existing review and publish an amended one
The reasons for deletion of reviews are available here.
Based on 32 customer reviews
Sort reviews by :
published the 25/11/2023following an order made on 31/10/2023
published the 05/10/2023following an order made on 12/09/2023
published the 20/09/2023following an order made on 27/08/2023
Bonne construction, c'est parfait....
published the 12/08/2023following an order made on 24/07/2023
published the 05/06/2023following an order made on 29/04/2023
rapport qualité prix
published the 14/02/2023following an order made on 31/01/2023
Très bien, conforme à mes attentes, je recommande !
published the 09/02/2023following an order made on 28/01/2023
Pas encore mis en place,toute mon installation est à peine commencé je mettrais un com à la fin de mes travaux
published the 18/01/2023following an order made on 02/11/2022
Fait le boulot. Si on doit remplacer le fusible, il est solidaire des câbles, j'aurais bien vu de pouvoir changer le fusible en laissant les câbles en place pour éviter de les mettre en contact en cas de gros défaut
published the 19/12/2022following an order made on 07/10/2022
pas encore mis en place
published the 14/11/2022following an order made on 26/08/2022